The ignition temperature of a diesel oxidation catalyst (DOC) and the internal temperature-field distribution of the diesel particulate filter (DPF) during active regeneration are investigated during an engine bench test in this study. Based on the dropped to idle (DTI) test, a test method is developed to determine the safe regeneration temperature of the DPF. The results show that when the inlet temperature of the DOC is more than 240 °C, the DOC begins ignition and reaches the target temperature of 600 °C set for active regeneration of DPF; when the inlet exhaust temperature of the DOC is between 240 and 280 °C, a higher injection rate is required to reduce the secondary pollution of HC and thus make the DPF reach the set target temperature as soon as possible. The active regeneration process of the DPF is divided into three stages. During ignition, the temperature of the DPF inlet and outlet increases rapidly and successively. The internal and outlet temperatures of DPF during regeneration are approximately 50 °C higher than the inlet temperature. At the end of regeneration, the DPF inlet to outlet temperature drops rapidly. A feed-forward design and feedback algorithm are used to verify the change in the target regeneration temperature. The overshoot of the DPF control strategy was less than 3%, and the steady-state temperature control error was less than 20 °C. The results of this study provide a basis for the safe control of DPFs’ active regeneration temperatures.

» Author: Hao Sun

» Reference: doi: 10.3390/pr10071246

» Publication Date: 22/06/2022

» More Information

« Go to Technological Watch